Good workholding turns a decent machine into a reliable producer. For aluminum or mild steel parts, use modular vises or zero-point plates to drop in fixtures quickly between jobs. Torque everything evenly-uneven clamping warps thin sections and throws off hole locations. Add locating pins or edge finders for repeatability; soft jaws custom-milled to your part profile grip better than parallels alone. On taller work, step clamps or toe clamps prevent lift, especially during rigid tapping reversals. Vacuum tables work great for flat plates but watch for leaks on porous stock. Always indicate the table after setup; even 0.005 mm tilt adds up over 500 mm. The TMC-800L handles 350 kg loads comfortably, so heavier fixtures aren't an issue. Its 1000x500 table gives room for multiple parts or a tombstone setup, boosting output on family-of-parts runs. Probe the first piece to catch any offset errors early, then trust the ±0.003 mm repeat accuracy for the rest of the batch. Shops that nail this see setup times drop below 15 minutes and scrap rates near zero.
How should you set up workholding for consistent results on a precision tapping machine?
Mar 23, 2026
Leave a message
